What DCC feeders are
A feeder is a short pair of wires that connects the rails to the power bus. In a typical layout, the command station connects to a heavier bus pair, and the feeders tap off that bus and attach to the rails at intervals. The feeders deliver power and the DCC signal to the track.
For the bigger wiring picture, see the model train track wiring guide.
Why rail joiners are not enough
Rail joiners can carry current, but they depend on a tight mechanical fit. Over time, joints can oxidize, loosen or expand and contract, and a handful of poor joints across a layout can cause stalls and flickering lights. Feeders give the power a more reliable path, so a poor joiner is less likely to take a section dead.
As a forum builder put it, in theory you only need one pair of connections, but the track is not a good wire, so in practice you need many.
How many feeders do you need?
There is no official number, and opinions vary, so treat these as rules of thumb:
- At minimum, every separate section of track should have its own feeder pair, such as each turnout, each siding and each isolated section.
- On continuous runs, many modelers connect a pair roughly every few feet, or to each length of flex track, as cheap insurance against dirty joints.
- If in doubt, add more. A feeder costs a few inches of wire and a few minutes of work. Missing feeders cost troubleshooting time.
Smaller scales and lightly loaded layouts can often get by with fewer. Larger scales, long trains and sound locomotives draw more current, so more feeders help. Track that is soldered at the joints, rather than relying on loose joiners, needs fewer.
One reassuring fact from the forum discussions is that feeders do not each carry a fraction of the voltage. Each carries current only as needed by locomotives near it, so more feeders improves how power reaches the rails.
Where to put them
Use this checklist as you plan:
- Every length of flex track on a long straight, or about every few feet.
- On both sides of every turnout, and on the frog if the design requires it. See turnouts and point motors for model railways.
- On each siding, spur and yard track.
- At each end of any section divided by insulated gaps.
- On reverse loops and wyes, through the reverser. See reverse loops and wyes.
- Near any place where locomotives tend to stall or slow down.
Place them where the wire can be hidden, such as behind scenery or under ballast, and plan this before you lay track permanently.
How to connect feeders to the rail
- Soldering to the outside of the rail web is the most solid method for most track. Clean the rail, tin it and use a heat sink so the ties do not melt.
- Drill the baseboard under the rail so the wire can drop straight through.
- Join feeders to the bus with terminal blocks, suitcase connectors or soldered splices, depending on your wire sizes. Make sure the connectors are rated for the wire.
- Keep polarity consistent: the same bus wire should always go to the same rail across the layout. Colour-code wires.
Some track systems with built-in terminals allow you to clip a feeder on, which is quick but can be less reliable than solder.
Feeder wire size and length
Feeders are usually thinner than the bus. Many HO modelers use somewhere in the 18 to 22 AWG range, and keep them as short as practical. One forum recommendation for a large O layout was to keep feeders under about 3 feet, since a long thin wire is where voltage drops. The sizes are discussed in what wire gauge to use for a model railroad DCC bus.
Testing
After installing feeders, run a locomotive slowly around the entire layout and watch for hesitation. Then try a locomotive with sound, which tends to reveal power problems sooner. Use a multimeter to compare voltage at the farthest rail and at the power source while a locomotive is running. If one area still stalls, add a feeder there, check the nearby rail joints and review your DCC connection in how to power a DCC track.