Floor or carpet: what to expect
A floor layout is a quick and inexpensive way to run trains, and many people do it for the holidays. Snap-together track such as Lionel FasTrack clips together in a way similar to slot-car track, which makes it well suited to floors and carpets. On a hard floor, track generally stays put once the pieces are clipped together. On carpet, pieces can shift, joints can flex and static or lint can affect running, so expect to do a little more cleaning and checking.
What you need
- A train set with snap-together track (FasTrack is a common choice), or a track pack that matches your set.
- A transformer or power supply appropriate for the set.
- Optionally a flat base, such as a sheet of plywood or a few hardboard panels, for carpet.
- A cloth and track cleaner.
- A power strip you can switch off.
Choosing a spot and a size
Pick a spot that is not a main walkway, and keep the layout away from heaters or fireplaces. Starter sets often come with an oval of O36 curves. A circle of FasTrack O36 is a little under 40 inches wide, so a small oval needs a rug-sized area, and you can see how large other options are in how much space an O gauge layout needs. If you have an older set, see O27 model train layouts for what its track can do.
Leave room around the layout to reach the track. A layout under a tree needs particular care, because needles and decorations can get onto the track.
Laying the track
- Sketch the layout on paper first, or at least lay out the pieces without connecting them to test the shape.
- Connect the pieces firmly. FasTrack pieces click together; make sure each joint is fully seated so power passes across it.
- Keep curves at least as wide as your locomotive’s minimum rating.
- Check that the track lies flat and doesn’t kink. On carpet, a hardboard or plywood base keeps the track level and the pieces from drifting.
- Add switches and sidings after the basic loop works.
For layout ideas, see Lionel FasTrack layout plans for a 4x8 table and small Lionel train layouts.
Powering the layout
Connect the transformer or lock-on to the track and test the train on a short run first. Larger loops can lose power at the point farthest from the connection. The Lionel Collectors Club suggests adding another feed from the transformer at a spot as far from the first connection as possible. If your layout has more track, you may need more feeders. Our guide to wiring an O scale layout explains more.
Running and safety
- Keep cords out of walkways and don’t leave a powered layout unattended.
- Keep children and pets away from the transformer, wires and small parts.
- Switch off power at the power strip when you are done.
- Don’t use a damaged cord or a transformer that gets very hot.
- Use a transformer rated for the equipment; modern power supplies are safer than very old ones.
Keeping track clean
Dirty track is the most common cause of poor running. The Lionel Collectors Club notes that a black film can build up on the rails from the wheels. It recommends a citric-based all-purpose cleaner, since alcohol-based cleaners can affect electrical connectivity, and says any cleaner should be wiped off before running trains. Denatured alcohol is also reported to work well. Don’t use abrasives or steel wool. Carpet fibers and dust may also need regular wiping.
Taking it down and storing it
Unclip the pieces gently and store them flat, ideally in their original boxes or a labeled bin. Keep the wiring and transformer together with the track. Note which pieces made up your layout, so that next year’s setup is quicker. Some hobbyists who build a temporary layout each year use tabletop sections that bolt together, sometimes on wheels, so the layout can be rolled away.
Making it semi-permanent
If you enjoy it, you can move up to a board or table so that the layout stays up longer. Foam over plywood is a lightweight base that stays portable, and a cork layer under the track helps with noise. For a broader overview of where to go next, see O gauge and Lionel layout plans.