What a shelf or around-the-walls layout is
A shelf layout is a narrow railroad built along one wall, like a long shelf. An around-the-walls layout extends the idea along several walls, or all the way around the room, leaving the centre open. Both aim to give you track and scenery without taking over the whole floor.
This approach is common in small rooms and in houses where the railroad shares space with other uses. It fits well with compact layout ideas.
Pros and cons
Advantages
- The middle of the room stays free.
- You can see and reach the layout easily if it is narrow.
- It suits point-to-point operation and switching.
- Benchwork is simple, and can be built in sections.
Drawbacks
- Continuous running may need to go around the room, or use turnbacks.
- Corners need careful design.
- Doorways may interrupt the layout.
- Scenes are linear, which can feel repetitive without good planning.
Depth and height
Depth is the most important design choice. Many shelf layouts are somewhere between about 12 and 24 inches deep, although the right figure depends on the scale, track plan and your reach. A narrow shelf leaves room for a single track and a thin strip of scenery; a deeper shelf allows more variety, but you must be able to reach the back.
Height depends on how you want to view the layout. A higher layout lets people stand and see trains near eye level, while a lower one suits sitting or children. Consider what is comfortable for you and your visitors. Work out how to reach track at the back, especially in corners.
Corners and turnbacks
Corners are the trickiest part of an around-the-walls plan. Options include:
- Wide curves in the corners. Gives smooth running but uses up space and often needs a deeper bench.
- Turnback curves at the ends of a shelf, so trains can reverse direction. These can be hidden behind a backdrop or scenery.
- Point-to-point operation, where trains run to the end and back, so corners can be gentler.
Check the minimum radius of your equipment before you draw the corners. See minimum curve radius for HO scale.
Doors and windows
If the layout must cross a doorway, common solutions include:
- A duck-under section that you pass beneath
- A lift-out or swing-up section that can be removed or raised (see fold-down and space-saving layouts)
- A swing gate that opens like a door
- Ending the layout at the door and using a hidden fiddle yard at each end
Whichever you choose, make sure the track joint is reliable and the section is easy to operate. Avoid designs that make you take the layout apart every time you enter the room. Windows can be an advantage for light, but direct sunlight can fade models and warp scenery, so consider blinds.
Backdrop and lighting
A backdrop makes a narrow layout look larger and hides the wall. A simple painted sky can be enough. A valance or fascia above the layout can hide lights and separate the layout from the room. Even lighting makes photographs and viewing easier.
Track plan ideas
- A long point-to-point line with a station at one end and staging at the other; see point-to-point versus loop layouts
- A switching layout with several industries along one wall; see switching layouts and car cards
- A walk-in or around-the-room loop if space allows and you want continuous running
Mistakes to avoid
- A shelf deeper than you can reach across
- Sharp corner curves that do not suit your equipment
- Doorway sections that are hard to use
- Hiding track where you cannot get to it
- Putting everything in a straight line, with no breaks in the scenery
For the broader process of designing a layout, see planning your model railroad.