Scales and Gauges

How big is the N scale compared to the HO scale?

N scale models are about 54% the length of HO models, at 1:160 versus 1:87.1. See a size table, track gauge comparison and what it means for your layout.

On this page
  1. Short answer
  2. Size comparison table
  3. Linear size vs floor area
  4. What it means for curves and layouts
  5. UK N gauge is slightly different
  6. Seeing it in practice

Short answer

N scale (1:160) models are about 54% as long as HO models (1:87.1). Put another way, HO is roughly 1.8 times the size of N in every direction. Because that applies in both length and width, a given real-world scene takes up about one third of the floor area in N compared with HO.

N is often described as “half the size of HO”. That is a good rule of thumb for length, but it is slightly generous to HO.

Size comparison table

These figures are calculated from the scale ratios. Real models vary slightly.

HO scale (1:87.1) N scale (1:160)
Track gauge 16.5 mm (0.65 in) 9 mm (0.35 in)
40-foot boxcar about 5.5 in (140 mm) 3 in (76 mm)
50-foot boxcar about 6.9 in (175 mm) about 3.75 in (95 mm)
6-foot person about 0.8 in (21 mm) about 0.45 in (11 mm)
Commonly quoted minimum radius about 18 to 22 in about 10 to 12 in

The minimum radius figures are rules of thumb from modelers and manufacturers. Longer locomotives, such as modern six-axle diesels, and passenger cars need wider curves. Check the instructions for each model you buy, and see our guides to HO minimum curve radius and N scale minimum radius.

Linear size vs floor area

The ratio of the two scales is 160 ÷ 87.1, which is about 1.84. That is the factor by which HO is bigger in length, width and height.

Area scales with the square of that number, so about 3.4. In other words, the same size of real-world scene takes about 3.4 times the floor area in HO. You will sometimes see claims that N fits “eight times as much” into the same space. That figure is not supported by the geometry, and a more realistic expectation is a bit over three times. It is still a big advantage for small rooms.

What it means for curves and layouts

Smaller models can use tighter curves, and tighter curves fit in less space. A 4 x 8 foot board is a tight fit for HO and comfortable for N. If you also want long trains and gentle curves, N lets you get closer to real railroading in a given room.

There is a trade-off at the other end of the scale. Small N parts can be fiddly, and a layout that is very small may not feel scenic enough. HO vs N scale covers the handling, electronics, cost and range comparisons.

UK N gauge is slightly different

In Britain, N gauge is built to 1:148 on the same 9 mm track. British N models are therefore a little larger than N in North America or continental Europe, about 8% in length. If you mix British and continental N products, watch for these differences.

Seeing it in practice

Photographs are rarely a good guide to size. If you can, put an HO and an N boxcar side by side at a hobby shop or train show. A 40-foot car that is 5.5 inches long in HO will be about 3 inches long in N (more figures in what is the size of an N scale train), small enough that many people want a magnifier for close work. The model train scales and gauges chart shows how both fit among the other scales, and what is the best scale for model trains can help you decide between them. You cannot run one on the other’s track: see can you run HO trains on N scale track.

The complete guide to scales and gauges

Model Train Scales and Gauges: The Complete Chart
Read the guide

Keep exploring

Guides from other topics

All topics →